Cogged V-Belts
Raw Edged Cogged Belt
The Raw Edged Cogged Belts have two cut surfaces on both sides, so its resistance to bending and heat dissipation are better than wrapped belts. Short fibers are mixed in the rubber in the direction of the belt's width, contributing to power transmission and helping to resist abrasion caused by side pressure.
Application: Used on heavy duty, high speed drives
Main Type: FMX, AX, BX, CX, 3VX, 5VX, XPZ, XPA, XPB and XPC
| Section | Top width (mm) | Thickness (mm) | Length range (mm) | Angle |
|---|---|---|---|---|
| AX | 13 | 8 | 356-3000 | 40° |
| BX | 17 | 11 | 533-3000 | 40° |
| CX | 22 | 14 | 800-3000 | 40° |
| DX | 32 | 13 | 1800-3000 | 40° |
Banded Cogged V-Belt
Application: Used for vertical shaft drives such as agitators and mixers.
Main Type: RAX, RBX, RCX, R3VX and R5VX
| Section | Top width (mm) | Thickness (mm) | Length range (mm) | Angle |
|---|---|---|---|---|
| RAX | 13.6 | 10 | 1200~3000 | 40° |
| RBX | 17 | 13 | 1200~3000 | 40° |
| RCX | 22.4 | 16 | 1800~3000 | 40° |